Rohde & Schwarz ESW Series - Page 609

Remote Commands in the Receiver Application
R&S
®
ESW
609User Manual 1177.6298.02 ─ 08
Make sure that the title string is not too long, because strings
that are too long could mess up the layout of the report.
Example:
HCOP:TREP:ITEM:HEAD:LINE3:TITL 'Device under
Test'
Renames the third title into "Device under Test".
Manual operation: See "Custom information about the measurement" on page 295
HCOPy:TREPort:ITEM:HEADer:STATe <State>
This command includes or excludes the complete set of measurement information from
the test report.
Parameters:
<State> ON | OFF
*RST: ON
Example:
HCOP:TREP:ITEM:HEAD:STAT ON
Includes the measurement information in the test report.
Manual operation: See "Custom information about the measurement" on page 295
HCOPy:TREPort:ITEM:LIST? [<ChannelType>]
This command queries the selected information to be included in the test report for a
specific channel type.
Parameters:
<ChannelType> Selects the channel type that you want to query the test report
configuration for.
When you omit the parameter, the command returns the configu-
ration of the currently selected channel.
Example:
HCOP:TREP:ITEM:LIST? SAN
Queries the items that are included in the test reports of the
Spectrum application.
Usage: Query only
Table 15-5: Available <ChannelTypes>
<ChannelType>
CAPD CISPR APD
IQ I/Q Analyzer
REC Receiver
RTIM Real-Time
SAN Spectrum
Data Management