Rohde & Schwarz ESW Series - Page 610

Remote Commands in the Receiver Application
R&S
®
ESW
610User Manual 1177.6298.02 ─ 08
HCOPy:TREPort:ITEM:LOGO <FileName>
This command selects a graphic (for example a company logo) that is shown at the top
of each page in the test report.
Use HCOPy:TREPort:ITEM:LOGO:CONTrol on page 610 to select the conditions
under which the picture is shown.
Parameters:
<FileName> String containing the location and name of the picture.
You can use the following file types: bmp, jpg, png, gif, emf or
wmf format.
Example:
HCOP:TREP:ITEM:LOGO 'C:\aPicture.jpg'
Includes a picture at the top of each page of the report.
Manual operation: See "Custom information about the measurement" on page 295
HCOPy:TREPort:ITEM:LOGO:CONTrol <Repitition>
This command selects how often the logo is displayed in the document.
Parameters:
<Repitition> GLOBal
The selected header line is displayed at the top of every page of
the report.
NEVer
The selected header line is displayed on no page of the report.
Note that a line that does not contain anything is still displayed in
the report as a blank line. If you select NEVer, the line is not dis-
played at all.
*RST: NEVer
Example:
HCOP:TREP:ITEM:LOGO 'c:\logo.png'
Selects a picture to be displayed in the report document.
HCOP:TREP:ITEM:LOGO:CONT SECT
Displays the logo after each subreport.
Manual operation: See "Custom information about the measurement" on page 295
HCOPy:TREPort:ITEM:SELect [<ChannelType>],'<Item>,<Item>,<Item>,...'
This command defines the type of information that a test report is made up out of.
Parameters:
<ChannelType> Optional parameter to define the channel type that the selection
applies to.
When you omit the <ChannelType> parameter, the selection
applies to the currently active channel.
<Item> String containing the information you want to include in the test
report.
Data Management