Rohde & Schwarz ESW Series - Page 632

Remote Commands in the Receiver Application
R&S
®
ESW
632User Manual 1177.6298.02 ─ 08
Example:
CORR:SWIT:DEF 'SYST:PRES'
Presets the switch matrix to its default state before the actual
measurement starts.
Manual operation: See "RF switch control" on page 325
[SENSe:]CORRection:SWITch:DEFault:EXECute
This command deliberately sends the command defined by [SENSe:]CORRection:
SWITch:DEFault[:COMMand] to the switch matrix.
Example:
CORR:SWIT:DEF 'SYST:PRES'
CORR:SWIT:DEF:EXEC
Sends SYSTem:PRESet to the switch matrix and restores its
default configuration.
Usage: Event
Manual operation: See "RF switch control" on page 325
[SENSe:]CORRection:SWITch:DELete <FileName>
This command deletes a dataset that controls a switch matrix.
Parameters:
<FileName> String containing the file name and path.
Example:
CORR:SWIT:DEL 'aSwitchProgram'
Deletes the dataset called "aSwitchProgram.xml".
Usage: Event
[SENSe:]CORRection:SWITch:INPut <Input>
This command selects the RF input of the R&S ESW used for the measurement with
the switch matrix.
Parameters:
<Input> INP1
Selects RF input 1.
INP1
Selects RF input 2.
OFF
No input is used.
Example:
CORR:SWIT:INP INP1
Measurement takes place on RF input 1.
Manual operation: See "RF input selection" on page 325
General Instrument Setup