Rohde & Schwarz ESW Series - Page 77

Operating the Instrument
R&S
®
ESW
77User Manual 1177.6298.02 ─ 08
6.5.2.3 How to Add a New Result Window
Each type of evaluation is displayed in a separate window. Up to 16 individual windows
can be displayed per channel (i.e. per tab).
1. Activate SmartGrid mode.
All evaluation methods available for the currently selected measurement are dis-
played as icons in the evaluation bar.
2. Select the icon for the required evaluation method from the evaluation bar.
If the evaluation bar contains more icons than can be displayed at once on the
screen, it can be scrolled vertically. Touch the evaluation bar between the icons
and move it up or down until the required icon appears.
3. Drag the required icon from the evaluation bar to the SmartGrid, which is displayed
in the diagram area, and drop it at the required position. (See Chapter 6.5.2.5,
"How to Arrange the Result Windows", on page 77 for more information on posi-
tioning the window).
Remote command:
LAYout:ADD[:WINDow]? on page 518 / LAYout:WINDow<n>:ADD? on page 522
6.5.2.4 How to Close a Result Window
► To close a window, activate SmartGrid mode and select the "Delete" icon for the
window.
Remote command:
LAYout:REMove[:WINDow] on page 520 / LAYout:WINDow<n>:REMove
on page 523
6.5.2.5 How to Arrange the Result Windows
1. Select an icon from the evaluation bar or the "Move" icon for an existing evaluation
window.
2. Drag the evaluation over the SmartGrid.
Displaying Results