Rohde & Schwarz SMAB-B92 - LF Signal Output Settings

Analog Modulations
R&S
®
SMA100B
104User Manual 1178.3834.02 ─ 05
Remote command:
[:SOURce<hw>]:NOISe:BANDwidth|BWIDth on page 625
[:SOURce<hw>]:NOISe:BWIDth:STATe on page 625
4.4.7 LF Signal Output Settings
Access:
► Select "Modulation" > "LF Output".
In the "LF Output" tab, you can configure the signal at the LF outputs, determine
the output voltage or add a DC offset. Activate both paths to output the sum signal
of the two sources.
Settings:
State............................................................................................................................104
Source.........................................................................................................................105
Show Connector..........................................................................................................105
Output Voltage............................................................................................................ 105
DC-Offset.................................................................................................................... 105
Noise Level................................................................................................................. 105
└ Noise Density................................................................................................105
└ Noise Level................................................................................................... 106
State
Activates the output of the LF signal.
Modulation Settings