Rohde & Schwarz SMAB-B92 - Source Subsystem

Remote Control Commands
R&S
®
SMA100B
511User Manual 1178.3834.02 ─ 05
Manual operation: See "Sensor type and serial number" on page 218
:SENSe<ch>[:POWer]:ZERO
Performs zeroing of the sensor.
Zeroing is required after warm-up, i.e. after connecting the sensor.
Note: Switch off or disconnect the RF power source from the sensor before zeroing.
We recommend that you zero in regular intervals (at least once a day), if:
●
The temperature has varied more than about 5 °C.
●
The sensor has been replaced.
●
You want to measure very low power.
Example:
SENS1:ZERO
Executes zeroing.
Usage: Event
Manual operation: See " Zero " on page 218
13.16 SOURce Subsystem
The SOURce subsystem contains the commands for configuring the digital and analog
signals.
Common suffixes
The following common suffixes are used in remote commands:
Suffix Value range Description
SOURce<hw>
[1]
●
SOURce[1] = RF output
(optional keyword)
●
LF output = SOURce:LFOutput
(SOURce is optional keyword)
● Analog Modulation Subsystems............................................................................512
● Avionic Standards Subsystems.............................................................................540
● SOURce:CORRection Subsystem........................................................................582
● SOURce:FREQuency Subsystem.........................................................................590
● SOURce:INPut Subsystem................................................................................... 598
● SOURce:LFOutput Subsystem............................................................................. 599
● SOURce:LIST Subsystem.....................................................................................612
● SOURce:NOISe Subsystem................................................................................. 625
● SOURce:PGEN Subsystem..................................................................................626
● SOURce:PHASe Subsystem................................................................................ 628
● SOURce:POWer Subsystem................................................................................ 629
● SOURce:ROSCillator Subsystem......................................................................... 637
● SOURce:SWEep Subsystem................................................................................643
SOURce Subsystem