Reference Oscillator
R&S
®
SMA100B
276User Manual 1178.3834.02 ─ 05
"1 GHz"
Outputs a 1 GHz signal.
"Input Signal (loop through)"
Forwards the external reference frequency to the output directly.
Remote command:
[:SOURce]:ROSCillator:OUTPut:FREQuency:MODE on page 641
[:SOURce]:ROSCillator:OUTPut:ALTernate:FREQuency:MODE on page 642
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
8.5 Adjustment Settings
Access:
1. Select "Frequency" > "Reference Freq"
2. Select "Adjustment".
Settings:
Adjustment Active....................................................................................................... 276
Adjustment Value........................................................................................................ 276
Adjustment Active
Selects the adjustment mode.
"OFF"
Uses the calibrated internal reference frequency.
"ON"
Allows you to apply a deviation to the internal reference frequency,
according to your requirements.
Enter the value in the Adjustment Value field.
Remote command:
[:SOURce]:ROSCillator[:INTernal]:ADJust[:STATe] on page 643
Adjustment Value
Sets a user-defined adjustment value for the internal reference frequency. This value
takes effect when it is activated with Adjustment Active.
●
"0" represents the calibrated state.
●
The setting range depends on the reference oscillator type and its factory calibra-
tion value.
Note:
The setting is not affected by an instrument preset ([Preset] key or *RST) and the
"Save/Recall" function. It is reset only by factory preset.
Adjustment Settings
To Next Page
Loading...
