Getting Started
R&S
®
SMA100B
43User Manual 1178.3834.02 ─ 05
RF
Rear panel connector for the RF signal. This connector is for use of the instrument in a
19" rack.
2.3 Trying Out the Instrument
This chapter introduces the first steps with the R&S SMA100B. It shows how to oper-
ate and configure the instrument using simple examples. The complete description of
the functionality and its usage is given in the R&S SMA100B user manual. Basic instru-
ment operation is described in Chapter 2.4, "Instrument Control", on page 50.
Prerequisites
The instrument is set up, connected to the power supply, and started up as described
in Chapter 2.1, "Preparing for Use", on page 21.
The first signal generation tasks explain how to generate an unmodulated signal, to
configure the RF signal output, and how you can vary the RF frequency and level in
sweep mode.
The instrument is manually operated via the touchscreen. Try out the following:
● Generating an Unmodulated Carrier.......................................................................43
● Generating an RF Frequency Sweep Signal...........................................................46
● Saving and Recalling Settings................................................................................ 48
2.3.1 Generating an Unmodulated Carrier
We start to generate a simple unmodulated signal. In this example, the R&S SMA100B
can be in its minimal configuration.
1. On the R&S SMA100B front panel, press the [Preset] key to set a defined initial
instrument state.
2. Set the frequency:
a) In the "Status Bar", tap the "Frequency" field.
b) On the on-screen keypad, enter "6" and press the "GHz" key.
Trying Out the Instrument
To Next Page
Loading...
