Rohde & Schwarz SMAB-B92 - Source:power Subsystem

Remote Control Commands
R&S
®
SMA100B
629User Manual 1178.3834.02 ─ 05
Example: See Example "Programming Example" on page 628.
Usage: Event
Manual operation: See "Reset Delta Phase Display" on page 72
13.16.11 SOURce:POWer Subsystem
The SOURce:POWer subsystem contains the commands for setting the output level,
level control and level correction of the RF signal.
The default units are dBm. To change the units, perform on of the following:
●
Enter the unit after the numerical value
Example: :POW 0.5V
●
Set the unit with the command :UNIT:POWer.
[:SOURce<hw>]:POWer:ALC[:STATe].............................................................................. 629
[:SOURce<hw>]:POWer:ALC:DSENsitivity....................................................................... 630
[:SOURce<hw>]:POWer:ALC:SONCe.............................................................................. 630
[:SOURce<hw>]:POWer:ATTenuation:RFOFf:MODE......................................................... 630
[:SOURce<hw>]:POWer:EMF:STATe................................................................................631
[:SOURce<hw>]:POWer:LBEHaviour............................................................................... 631
[:SOURce<hw>]:POWer:LIMit[:AMPLitude].......................................................................631
[:SOURce<hw>]:POWer:LMODe..................................................................................... 632
[:SOURce<hw>]:POWer:MANual.....................................................................................632
[:SOURce<hw>]:POWer:MODE.......................................................................................633
[:SOURce<hw>]:POWer:POWer......................................................................................633
[:SOURce<hw>]:POWer:STARt....................................................................................... 634
[:SOURce<hw>]:POWer:STOP........................................................................................634
[:SOURce<hw>]:POWer:STEP:MODE............................................................................. 634
[:SOURce<hw>]:POWer:STEP[:INCRement].................................................................... 634
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:OFFSet........................................................ 635
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:RCL............................................................. 635
[:SOURce<hw>]:POWer[:LEVel][:IMMediate][:AMPLitude]..................................................636
[:SOURce<hw>]:POWer:RANGe:LOWer?........................................................................ 636
[:SOURce<hw>]:POWer:RANGe:UPPer?.........................................................................636
[:SOURce]:POWer:WIGNore...........................................................................................637
[:SOURce<hw>]:POWer:ALC[:STATe] <State>
Parameters:
<State> 0 | OFF | AUTO | 1 | ON | ONTable | PRESet | OFFTable
AUTO
Adjusts the output level to the operating conditions automati-
cally.
1|ON
Activates internal level control permanently.
OFFTable
Controls the level using attenuation values of the internal ALC
table.
SOURce Subsystem