Rohde & Schwarz SMAB-B92 - Creating Screenshots of Current Settings; Hardcopy Settings

File and Data Management
R&S
®
SMA100B
311User Manual 1178.3834.02 ─ 05
2. On each R&S SMA100B, use the same alias name for the directory of the file
server, i.e. enter the same "Local Folder" (in this example Setups).
On any of the R&S SMA100B, you access the file server directly from the "File
Manager" and under the same name, e.g. /shares/Setups.
An extra advantage in remote control is that the same application program would
control the instruments.
For example, use the remote control command MMEMory:CDIRectory
"/shares/Setups" to set the default directory for mass storage.
10.10 Creating Screenshots of Current Settings
The save/recall function enables you to save current settings in a file. To document the
most important settings for a performed signal generation, you can also save a hard-
copy of the current display.
● Hardcopy Settings.................................................................................................311
● How to Save a Hardcopy of the Display................................................................315
10.10.1 Hardcopy Settings
Access:
► Select "System Config > Setup > User Interface > Hardcopy".
Creating Screenshots of Current Settings