Rohde & Schwarz SMAB-B92 - Amplitude Settings

Avionic Standards
R&S
®
SMA100B
138User Manual 1178.3834.02 ─ 05
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:MODE on page 567
DDM polarity
Defines the polarity for DDM calculation (see "DDM Depth" on page 140).
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:DDM:POLarity on page 564
Left Frequency
Sets the modulation frequency of the antenna lobe arranged at the left viewed from the
air plane.
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:LLOBe[:FREQuency] on page 567
Right Frequency
Sets the modulation frequency of the antenna lobe arranged at the right viewed from
the air plane.
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:RLOBe[:FREQuency] on page 568
Left/Right Phase
Sets the phase between the modulation signals of the left and right antenna lobe. The
zero crossing of the right lobe (150 Hz) signal serves as a reference. The angle refers
to the period of the signal of the right antenna lobe.
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:PHASe on page 568
5.4.3.3 Amplitude Settings
Access:
1. Select "ILS Component > Localizer", see Chapter 5.4.3, "ILS Localizer Settings",
on page 134.
ILS Configuration and Settings