Remote Control Commands
R&S
®
SMA100B
567User Manual 1178.3834.02 ─ 05
Parameters:
<SelIcaoChan> CH18X | CH18Y | CH20X | CH20Y | CH22X | CH22Y | CH24X |
CH24Y | CH26X | CH26Y | CH28X | CH28Y | CH30X | CH30Y |
CH32X | CH32Y | CH34X | CH34Y | CH36X | CH36Y | CH38X |
CH38Y | CH40X | CH40Y | CH42X | CH42Y | CH44X | CH44Y |
CH46X | CH46Y | CH48X | CH48Y | CH50X | CH50Y | CH52X |
CH52Y | CH54X | CH54Y | CH56X | CH56Y
*RST: CH18X
Example: See Example "Configure and generate an ILS localizer signal"
on page 543.
Manual operation: See "ICAO Channel" on page 136
[:SOURce<hw>]:ILS:LOCalizer:LLOBe[:FREQuency] <Frequency>
Sets the modulation frequency of the antenna lobe arranged at the bottom viewed from
the air plane for the ILS localizer modulation signal.
Parameters:
<Frequency> float
Range: 60 to 120
Increment: 0.03
*RST: 90
Example: See Example "Configure and generate an ILS localizer signal"
on page 543.
Manual operation: See "Left Frequency" on page 138
[:SOURce<hw>]:ILS:LOCalizer:MODE <Mode>
Sets the operating mode for the ILS localizer modulation signal.
Parameters:
<Mode> NORM | LLOBe | RLOBe
NORM
ILS localizer modulation is active.
LLOBe
Amplitude modulation of the output signal with the left lobe
(90Hz) signal component of the ILS localizer signal is active.
RLOBe
Amplitude modulation of the output signal with the right lobe
(150Hz) signal component of the ILS localizer signal is active.
*RST: NORM
Example: See Example "Configure and generate an ILS localizer signal"
on page 543.
Manual operation: See "Operating Mode" on page 137
SOURce Subsystem
To Next Page
Loading...
