General Instrument Functions
R&S
®
SMA100B
340User Manual 1178.3834.02 ─ 05
11.4.3 Configuring LAN Services
Access:
► Select "System Config > Setup > Security > Security > LAN Services".
In the "LAN Services" dialog, you can individually enable or disable the supported
LAN interface services.
The activated LAN services are not activated until you enter the "Security Password"
on page 341 and confirm with Accept.
LAN
Enables the LAN interface in general, and thus provides remote access via all
unlocked services.
Enable LAN Services individually
Enables or disables the following interface services individually.
"SCPI over LAN"
Activates access over LAN to control the instrument remotely, by
using SCPI (Standard Commands for Programmable Instruments)
commands.
See also "Starting a remote control session over LAN with R&S VISA"
on page 379.
Using the Security Settings
To Next Page
Loading...
