Rohde & Schwarz SMAB-B92 - LF Sweep Settings

Remote Control Commands
R&S
®
SMA100B
609User Manual 1178.3834.02 ─ 05
13.16.6.2 LF Sweep Settings
With the commands described in this section, you can configure the sweep of the LF
signal.
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:DWELl................................................... 609
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:EXECute................................................609
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:MODE....................................................609
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:POINts...................................................610
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RETRace............................................... 610
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RUNNing?.............................................. 611
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SHAPe...................................................611
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SPACing.................................................611
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP:LOGarithmic.................................. 611
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP[:LINear]........................................ 612
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:DWELl <Dwell>
Sets the dwell time for each frequency step of the sweep.
Parameters:
<Dwell> float
Range: 5E-4 to 100
Increment: 100E-6
*RST: 10E-3
Default unit: s
Example: See Example "Setup an LF sweep" on page 599.
Manual operation: See " Dwell Time " on page 174
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:EXECute
Immediately starts an LF sweep.
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:MODE determines which sweep
is executed, e.g. SOURce:LFOutput:SWEep:FREQuency:MODE STEP.
Example:
See Example "Setup an LF sweep" on page 599.
Usage: Event
Manual operation: See " Execute Single Sweep " on page 175
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:MODE <Mode>
Sets the cycle mode of the LF sweep.
Parameters:
<Mode> AUTO | MANual | STEP
SOURce Subsystem