Rohde & Schwarz SMAB-B92 - List Mode Settings

Remote Control Commands
R&S
®
SMA100B
615User Manual 1178.3834.02 ─ 05
● List Mode Settings.................................................................................................615
● List Mode File Operation.......................................................................................620
● List Mode Data Exchange.....................................................................................622
13.16.7.1 List Mode Settings
With the following commands, you can create list mode data, select the trigger mode
and determine the dwell time.
[:SOURce<hw>]:LIST:DWELl.......................................................................................... 615
[:SOURce<hw>]:LIST:DWELl:MODE................................................................................615
[:SOURce<hw>]:LIST:DWELl:LIST...................................................................................616
[:SOURce<hw>]:LIST:DWELl:LIST:POINts?......................................................................616
[:SOURce<hw>]:LIST:FREQuency...................................................................................616
[:SOURce<hw>]:LIST:FREQuency:POINts?......................................................................617
[:SOURce<hw>]:LIST:INDex............................................................................................617
[:SOURce<hw>]:LIST:INDex:STARt................................................................................. 617
[:SOURce<hw>]:LIST:INDex:STOP..................................................................................617
[:SOURce<hw>]:LIST:MODE...........................................................................................618
[:SOURce<hw>]:LIST:POWer..........................................................................................618
[:SOURce<hw>]:LIST:POWer:POINts?.............................................................................619
[:SOURce<hw>]:LIST:TRIGger:EXECute..........................................................................619
[:SOURce<hw>]:LIST:TRIGger:SOURce.......................................................................... 619
[:SOURce<hw>]:LIST:RUNNing?..................................................................................... 620
[:SOURce<hw>]:LIST:DWELl <Dwell>
Sets the global dwell time. The instrument generates the signal with the frequency /
power value pairs of each list entry for that particular period.
See also Significant Parameters and Functions.
Parameters:
<Dwell> float
Range: 1E-3 to 100
Increment: 1E-6
*RST: 0.01
Example: See Example "Create an RF list and activate the list mode"
on page 612.
Manual operation: See "Global Dwell Time" on page 184
[:SOURce<hw>]:LIST:DWELl:MODE <DwelMode>
Selects the dwell time mode.
Parameters:
<DwelMode> LIST | GLOBal
SOURce Subsystem