Rohde & Schwarz SMAB-B92 - Page 619

Remote Control Commands
R&S
®
SMA100B
617User Manual 1178.3834.02 ─ 05
You can either enter the data as a list of numbers, or as binary
block data.
The list of numbers can be of any length, with the list entries
separated by commas.
In binary block format, 8 (4) bytes are always interpreted as a
floating-point number with double accuracy.
See also :FORMat[:DATA].
Range: 300 kHz to RFmax (depends on the installed
options)
Example: See Example "Create an RF list and activate the list mode"
on page 612.
Manual operation: See "Edit List Mode Data" on page 190
[:SOURce<hw>]:LIST:FREQuency:POINts?
Queries the number (points) of frequency entries in the seleced list.
Return values:
<Points> integer
Range: 0 to INT_MAX
*RST: 0
Example: See Example "Create an RF list and activate the list mode"
on page 612.
Usage: Query only
[:SOURce<hw>]:LIST:INDex <Index>
Sets the list index in LIST:MODE STEP.
After the trigger signal, the instrument processes the frequency and level settings of
the selected index.
Parameters:
<Index> integer
*RST: 0
Example: See Example "Create an RF list and activate the list mode"
on page 612.
Manual operation: See " Current Index " on page 183
[:SOURce<hw>]:LIST:INDex:STARt <Start>
[:SOURce<hw>]:LIST:INDex:STOP <Stop>
Sets the start and stop index of the index range which defines a subgroup of fre-
quency/level value pairs in the current list.
SOURce Subsystem