Rohde & Schwarz SMAB-B92 - Signal Settings

Avionic Standards
R&S
®
SMA100B
145User Manual 1178.3834.02 ─ 05
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:FREQuency on page 572
5.4.4.2 Signal Settings
Access:
1. Select "ILS Component > Marker Beacons", see Chapter 5.4.4, "ILS Marker Bea-
cons Settings", on page 143.
2. Select "ILS > Signal".
This dialog comprises signal settings related to the ILS marker beacons compo-
nent of the ILS signal.
Settings
Marker Frequency.......................................................................................................145
Marker Depth.............................................................................................................. 145
Pulsed Marker.............................................................................................................145
Marker Frequency
Sets the modulation frequency of the marker signal.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:MARKer:FREQuency on page 573
Marker Depth
Sets the modulation depth of the marker signal.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon[:MARKer]:DEPTh on page 573
Pulsed Marker
Activates the modulation of a pulsed marker signal (morse coding).
ILS Configuration and Settings