Rohde & Schwarz SMAB-B92 - Source:vor Subsystem

Remote Control Commands
R&S
®
SMA100B
574User Manual 1178.3834.02 ─ 05
Parameters:
<Pulsed> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 544.
Manual operation: See "Pulsed Marker" on page 145
13.16.2.5 SOURce:VOR Subsystem
Option: R&S SMAB-K25
The SOURce:VOR subsystem contains all commands for configuring the VOR signal.
Characteristics which are valid for all modulations and the LF output are configured in
the SOURce:LFOutput subsystem. The signal is output at the LF connector.
Commands
[:SOURce<hw>]:VOR:SOURce....................................................................................... 574
[:SOURce<hw>]:VOR[:BANGle].......................................................................................575
[:SOURce<hw>]:VOR[:BANGle]:DIRection....................................................................... 575
[:SOURce<hw>]:VOR:COMid:CODE................................................................................575
[:SOURce<hw>]:VOR:COMid:DASH................................................................................576
[:SOURce<hw>]:VOR:COMid:DEPTh...............................................................................576
[:SOURce<hw>]:VOR:COMid:DOT.................................................................................. 576
[:SOURce<hw>]:VOR:COMid:FREQuency....................................................................... 577
[:SOURce<hw>]:VOR:COMid:LETTer...............................................................................577
[:SOURce<hw>]:VOR:COMid:PERiod.............................................................................. 577
[:SOURce<hw>]:VOR:COMid:SYMBol............................................................................. 578
[:SOURce<hw>]:VOR:COMid:TSCHema..........................................................................578
[:SOURce<hw>]:VOR:COMid[:STATe].............................................................................. 578
[:SOURce<hw>]:VOR:FREQuency.................................................................................. 579
[:SOURce<hw>]:VOR:FREQuency:MODE........................................................................579
[:SOURce<hw>]:VOR:ICAO:CHANnel..............................................................................579
[:SOURce<hw>]:VOR:MODE.......................................................................................... 580
[:SOURce<hw>]:VOR:REFerence[:DEViation]...................................................................581
[:SOURce<hw>]:VOR:SUBCarrier:DEPTh........................................................................ 581
[:SOURce<hw>]:VOR:SUBCarrier[:FREQuency]............................................................... 581
[:SOURce<hw>]:VOR:VAR:FREQuency........................................................................... 582
[:SOURce<hw>]:VOR:VAR[:DEPTh]................................................................................ 582
[:SOURce<hw>]:VOR:SOURce <VorSourceSel>
Sets the modulation source for the avionic standard modulation.
If external modulation source is set, the external signal is added to the internal signal.
Switching off the internal modulation source is not possible.
Parameters:
<VorSourceSel> INT | INT,EXT | EXT
SOURce Subsystem