Rohde & Schwarz SMAB-B92 - Page 578

Remote Control Commands
R&S
®
SMA100B
576User Manual 1178.3834.02 ─ 05
The COM/ID tone is sent according to the selected code, see Chapter D, "Morse Code
Settings", on page 740.
If no coding is set, the COM/ID tone is sent uncoded (key down).
Parameters:
<Code> string
Example: See Example "Configure and generate a VOR signal"
on page 544.
Manual operation: See "Code" on page 122
[:SOURce<hw>]:VOR:COMid:DASH
<Dash>
Sets the length of a Morse code dash.
Parameters:
<Dash> float
Range: 0.05 to 1
Increment: 1E-4
*RST: 0.3
Example: See Example "Configure and generate a VOR signal"
on page 544.
Manual operation: See "Dash Length" on page 123
[:SOURce<hw>]:VOR:COMid:DEPTh <Depth>
Sets the AM modulation depth of the COM/ID signal.
Parameters:
<Depth> float
Range: 0 to 100
Increment: 0.1
*RST: 10
Example: See Example "Configure and generate a VOR signal"
on page 544.
Manual operation: See "Depth" on page 123
[:SOURce<hw>]:VOR:COMid:DOT <Dot>
Sets the length of a Morse code dot.
If the time schema is set to standard, the dash length (= 3 times dot length), symbol
space (= dot length) and letter space (= 3 times dot length) is also determined by this
entry.
SOURce Subsystem