Network Operation and Remote Control
R&S
®
SMA100B
363User Manual 1178.3834.02 ─ 05
Stop Bits
Sets the number of stop bits for the serial remote control interface.
Remote command:
:SYSTem:COMMunicate:SERial:SBITs on page 667
12.4.5 Instrument Emulations Settings
Access:
► Select "System Config > Remote Access > Instrument Emulations".
The "Instrument Emulations" dialog enables you to emulate a remote control com-
mand set of another signal generator.
The remote commands required to configure the emulation settings remotely are
described in Chapter 13.17, "SYSTem Subsystem", on page 653.
Language
Selects the instrument whose remote command set is emulated by the R&S SMA100B.
Remote command:
:SYSTem:LANGuage on page 669
Mode
Selects the way the instrument identification is performed.
"Automatic"
Sets the "IDN String" and the "OPT String" automatically for the
instrument selected with the parameter Language.
"User Defined"
Enables you to define the "IDN String" and the "OPT String".
Remote command:
:SYSTem:IDENtification on page 668
Remote Access Settings
To Next Page
Loading...
