Rohde & Schwarz SMAB-B92 - List Mode Data Settings

List and Sweep Mode
R&S
®
SMA100B
185User Manual 1178.3834.02 ─ 05
"Negative"
The falling edge of the trigger signal triggers the instrument.
Remote command:
[:SOURce]:INPut:TRIGger:SLOPe on page 599
Reset
Resets the list to the starting point.
Remote command:
[:SOURce<hw>]:LIST:RESet on page 622
Execute Single
Manually starts list processing in "Single" mode.
Remote command:
[:SOURce<hw>]:LIST:TRIGger:EXECute on page 619
6.6.2 List Mode Data Settings
Access:
1. Select "Sweep" > "List mode".
2. Select "List Mode Data".
This dialog contains the parameters required for creating and editing lists, activat-
ing the learning function and selecting the list processing mode.
Settings
List Mode Data ...........................................................................................................185
Edit List Mode Data ....................................................................................................186
List Range from/to ......................................................................................................186
List Mode Data
Accesses the standard "Select List" dialog for selecting, creating and editing a list file.
The currently loaded file is indicated.
You can create data lists with the internal editor or import externally created files, see
"Creating and handling lists" on page 167.
Remote command:
[:SOURce<hw>]:LIST:CATalog? on page 620
[:SOURce<hw>]:LIST:SELect on page 622
[:SOURce<hw>]:LIST:DELete on page 621
[:SOURce<hw>]:LIST:DELete:ALL on page 621
List Mode Settings