Rohde & Schwarz SMAB-B92 - Using the User Menu for Fast Adjustments

General Instrument Functions
R&S
®
SMA100B
323User Manual 1178.3834.02 ─ 05
Dialog identification
To identify each dialog, the instrument uses a dedicated dialog ID. The dialog ID con-
tains the dialog position on the display and the current active tab. The action that trig-
gers the instrument to open a dialog uses this identification.
Save/Recall vs. recall setup
Sometimes, you would like to restore a specific signal generation setup and perform
further configurations based on this particular instrument state. The R&S SMA100B
provides two ways to achieve this, by the "Save/Recall" function and by the "Recall
Setup" function.
●
"Save/Recall"
For a detailed description, refer to Chapter 10.4, "Saving and Recalling Instrument
Settings", on page 291.
●
"Recall Setup"
If the "Recall Setup" is the only one user action assigned to the [★ (User)] key,
pressing this key triggers the R&S SMA100B to load immediately the user-defined
preset file.
11.2.1 Using the User Menu for Fast Adjustments
By default, there is one predefined action assigned to the [★ (User)] key.
1. Press the [★ (User)] key.
The "User Menu" dialog opens.
If you execute this action for the first time, the dialog is empty.
2. Follow the instructions displayed in the "User Menu" dialog to build your own dialog
with settings.
3. Alternatively, proceed as follows:
a) Open a dialog with settings you frequently use.
b) Select a parameter.
Organizing Frequently Used Settings as Favorites