Rohde & Schwarz SMAB-B92 - Output; Amplitude; RF State;Rf on

RF Signal Configuration
R&S
®
SMA100B
68User Manual 1178.3834.02 ─ 05
The "Level" tile indicates the level limit, the user correction status and current cor-
rection value, current setting characteristics incl. mode.
The remote commands required to define the settings are described in Chap-
ter 13.16.11, "SOURce:POWer Subsystem", on page 629.
Settings
RF State/RF ON............................................................................................................68
Amplitude...................................................................................................................... 68
Limit ..............................................................................................................................69
Offset ............................................................................................................................69
Setting Characteristics ................................................................................................. 69
Mode ............................................................................................................................ 70
Harmonic Filter .............................................................................................................70
Level Range .................................................................................................................70
Readjust........................................................................................................................71
User Variation................................................................................................................71
└ Variation Active............................................................................................... 71
└ Variation Step..................................................................................................71
RF State/RF ON
Activates or deactivates the RF output.
Acts as the [RF on/off] key.
Remote command:
:OUTPut<hw>[:STATe] on page 445
Amplitude
Sets the level of the RF signal.
The value is offset-free and corresponds to the level at the RF connector.
See "RF frequency and level display with a downstream instrument" on page 63.
Note: Suppressed values in the status bar
For security concerns or certain operating modes, you can hide the frequency and
level display in the status bar.
●
The display has been disabled for security reasons.
See:
– Annotation Frequency
– Annotation Amplitude
●
The display is disabled when list mode is running, see Chapter 6, "List and Sweep
Mode", on page 154.
RF Level Settings