RF Signal Configuration
R&S
®
SMA100B
66User Manual 1178.3834.02 ─ 05
This value represents the multiplication factor of a downstream instrument, like for
example a multiplier.
The "Frequency" value displayed in the status bar is the resulting frequency, as it is at
the output of the downstream instrument. The frequency at the R&S SMA100B RF out-
put is not changed.
See "RF frequency and level display with a downstream instrument" on page 63.
Remote command:
[:SOURce<hw>]:FREQuency:MULTiplier on page 594
User Variation
Defines and activates a user-defined step width for varying the RF frequency or RF
level with the rotary knob.
If disabled, the step width varies in steps of one unit at the cursor position.
Variation Active ← User Variation
Activates the set user-defined step width.
Remote command:
[:SOURce<hw>]:FREQuency:STEP:MODE on page 596
[:SOURce<hw>]:POWer:STEP:MODE on page 634
Variation Step ← User Variation
Sets the user-defined step width.
Remote command:
[:SOURce<hw>]:FREQuency:STEP[:INCRement] on page 596
[:SOURce<hw>]:POWer:STEP[:INCRement] on page 634
3.4 RF Level Settings
Access:
1. Select "Level" > "RF Level".
RF Level Settings
To Next Page
Loading...
