Analog Modulations
R&S
®
SMA100B
106User Manual 1178.3834.02 ─ 05
Noise Level ← Noise Level
Indicates the level of the noise signal per Hz within the total bandwidth (absolute).
Remote command:
[:SOURce<hw>]:NOISe:LEVel[:ABSolute]? on page 626
4.4.8 Overview
Option: AM and FM/PM require R&S SMAB-K720
Access:
► Select "Modulation" > "Modulation Sources > Overview".
Blue color
= Active output signal (AM and FM)
Gray color = Inactive output signal (LF Out)
Miniature graph = Indicates an active source
Connectors = Indicate a connector (e.g. external signal) is involved in the path of the signal
The "Overview" tab is an interactive diagram that indicates the active modulations
and the signal being output.
Here you can:
● Select the output signal ("LF Out") in one or two paths; the setting acts as the
parameter "LF Output Source"
● Select the source for each modulation and modulation path; the setting acts as
the parameter "Source"
● Activate modulation in one or two paths; the setting acts as the parameter
"State"
Modulation Settings
To Next Page
Loading...
