Getting Started
R&S
®
SMA100B
53User Manual 1178.3834.02 ─ 05
Tile Access to:
"Modulation"
●
Analog and stereo
1)
, and pulse
1)
modulation settings
●
Built in LF generator
"System Config"
●
"Save/Recall": settings for saving and loading instrument configurations
●
"Remote access": Network and emulation settings.
●
"Setup": general system configuration
"Sweep"
●
Frequency and level sweeps
●
List mode
"Frequency"
●
RF frequency and phase
●
Reference frequency
"Level"
●
RF level
●
Attenuator
●
Automatic level control
●
User correction
"Clk Syn / Pow Sens"
●
Clock synthesis
1)
●
Power sensors
1)
requires additional options
2.4.3.3 Taskbar
The "Taskbar" shows a home and an info button, and assigns a labeled button when-
ever you open a dialog. If more dialogs are open than the taskbar can display, touch
and swipe the taskbar to scroll up and down.
The buttons shown in the following example represent the variants.
Table 2-8: Example of buttons in the taskbar
"Home" button
Returns to the home screen.
"User Menu"
Lists parameters that can be defined for quick access.
Shows the current remote access connections when the instrument is remotely con-
trolled.
Tip: An indicator in the "System Config" tile shows the current remote control status.
R&S NRP power sensors
Shows a connected external power sensor. The button displays the current readings
when the sensor is active.
Instrument Control
To Next Page
Loading...
