Maintenance
R&S
®
SMA100B
699User Manual 1178.3834.02 ─ 05
The dialog is divided in tabs, according to the hardware components of the signal
domains. The "Counter" tab provides information on the operation time and number
of times the instrument was powered on.
The remote commands required to query the hardware configuration are described in
Chapter 13.8, "DIAGnostic Subsystem", on page 430.
Assembly
The tables in the tabs show characteristics of the installed assemblies.
"Assembly"
Assembly designation.
"Part Number"
Part number of the assembly.
"Serial Number"
Serial number of the assembly.
"Revision"
Revision state of the assembly.
"Slot"
Indicates whether the assembly is connected to the serial bus or PCI
bus.
Remote command:
:DIAGnostic<hw>:BGINfo? on page 431
Counter
Displays information on the operation times of the R&S SMA100B.
Operation Time / h ← Counter
Displays the operation time in hours.
Remote command:
n.a.
Power On Count ← Counter
Displays the number of power-on.
Remote command:
n.a.
Last Factory Calibration ← Counter
Displays the date of the last factory calibration.
Remote command:
:CALibration:DATA:FACTory:DATE? on page 424
14.3.5.2 Versions/Options Settings
Access:
► Select "System Config > Setup > Instrument Assembly > Versions / Options".
Performing Maintenance Tasks
To Next Page
Loading...
