Rohde & Schwarz SMAB-B92 - RF Frequency Settings

RF Signal Configuration
R&S
®
SMA100B
64User Manual 1178.3834.02 ─ 05
3.3 RF Frequency Settings
Access:
1. Select "Frequency" > "RF Frequency".
2. Observe the information on the home screen, "Frequency" tile.
The "Frequency" tile indicates the reference frequency, current frequency offset
and multiplier values, and phase offset value.
In the "RF Frequency" dialog, you can configure:
● RF frequency, incl. an offset or multiplication factor of a downstream instrument
● The step size for varying the frequency with the rotary knob.
The remote commands required to define the settings are described in Chap-
ter 13.16.4, "SOURce:FREQuency Subsystem", on page 590.
Settings
Frequency..................................................................................................................... 65
Main PLL Bandwidth..................................................................................................... 65
Offset.............................................................................................................................65
Multiplier........................................................................................................................65
User Variation................................................................................................................66
└ Variation Active............................................................................................... 66
└ Variation Step..................................................................................................66
RF Frequency Settings