Maintenance
R&S
®
SMA100B
691User Manual 1178.3834.02 ─ 05
Remote command:
:SYSTem:TIME on page 674
Timezone
Selects the timezone.
You can select the timezone according to the major cities on the respective continents.
Note: By typing the first letter, you can quickly navigate through the lists to find the
desired destination.
Remote command:
:SYSTem:TIME:ZONE on page 675
:SYSTem:TIME:ZONE:CATalog? on page 675
NTP Address
Sets the IP address or host name of the NTP server.
NTP is a network time protocol used for synchronizing all participating devices in a
data network.
You can select a high-precision time server to reduce the impact of varying network
delays.
Remote command:
:SYSTem:NTP:HOSTname on page 674
Use Time from NTP Server
Activates clock synchronization of the network via the NTP protocol.
Remote command:
:SYSTem:NTP:STATe on page 674
14.3.2 Check Front Panel
Within this dialog, you can verify the functionality of the control keys.
For Instructions on how to perform the tests and the expected results, see Chap-
ter 14.3.2.2, "How to Test the Front Panel", on page 692
In case of malfunctions:
Contact the Rohde & Schwarz customer support, see Chapter 15.6, "Collecting Infor-
mation for Technical Support", on page 707.
Accessing the online help in the check front panel dialog or exiting via [Esc]
During the test, the actual functions of all keys are disabled, including the [Help] and
the [Esc] keys.
Performing Maintenance Tasks
To Next Page
Loading...
