Maintenance
R&S
®
SMA100B
690User Manual 1178.3834.02 ─ 05
The "Date / Time" dialog contains the time and data settings of the operating sys-
tem.
This function is password-protected. Unlock the protection level 1 to access it.
The required remote commands are described in Chapter 13.17, "SYSTem Subsys-
tem", on page 653.
To select the timezone
1. Press the [Setup] key.
2. Select "Maintenance > Date /Time > Timezone".
3. Select continent and city of your location.
Tip: By typing the first letter, you can quickly navigate through the lists to find the
desired destination.
4. Close the dialogs.
The instrument adjusts the time according to the selected location.
To set the date and time
1. Press the [Setup] key.
2. Select "Security > Protection".
3. Enable the "Protection Level 1".
The default password is 123456.
4. Select "Setup > Maintenance > Date / Time".
5. Adjust the settings.
6. Close the dialogs.
The instrument adopts the new date and time.
Settings:
Date.............................................................................................................................690
Time............................................................................................................................ 690
Timezone.....................................................................................................................691
NTP Address...............................................................................................................691
Use Time from NTP Server.........................................................................................691
Date
Displays the date set in the operating system in the format [dd.mm.yyyy].
Remote command:
:SYSTem:DATE on page 673
Time
Displays the time set in the operating system in the format [hh.mm.ss].
The time setting corresponds to the selected Use Time from NTP Server.
Performing Maintenance Tasks
To Next Page
Loading...
