Rohde & Schwarz SMAB-B92 - Fpga;Uc Update Settings

Maintenance
R&S
®
SMA100B
697User Manual 1178.3834.02 ─ 05
14.3.4 FPGA/uC Update Settings
Access:
► Select "System Config > Setup > Maintenance > FPGA/µC Update".
This dialog enables you to check for and install internal assembly updates.
Settings:
Check For Updates..................................................................................................... 697
Assembly.....................................................................................................................697
Install...........................................................................................................................697
Shut down................................................................................................................... 697
Check For Updates
Check for updates of the FPGA/µC.
Remote command:
n.a.
Assembly
The table shows the installed assemblies and their states.
"Assembly"
Assembly designation.
"State"
Indicates the current state of installed assemblies.
Install
Install all available updates for the FPGA/µC.
Remote command:
n.a.
Shut down
For at least one assembly "State = Done" and no pending assemblies, shuts the instru-
ment down to applies installed updates.
Performing Maintenance Tasks