Rohde & Schwarz SMAB-B92 - Position Settings

Avionic Standards
R&S
®
SMA100B
121User Manual 1178.3834.02 ─ 05
5.3.3 Position Settings
Access:
► Select "VOR > Position".
This dialog provides access to position settings related to the VOR modulation sig-
nal.
Settings
Bearing Angle..............................................................................................................121
Direction......................................................................................................................121
Bearing Angle
Sets the phase angle between the 30 Hz VAR signal and the 30 Hz reference signal.
The orientation of the angle depends on the set Direction.
Remote command:
[:SOURce<hw>]:VOR[:BANGle] on page 575
Direction
Sets the reference position of the phase information.
The angle set under "Bearing Angle" corresponds to the angle between the geographic
north and the connection line from beacon to airplane.
"From"
Selection of the beacon as a reference position.
"To"
Selection of the airplane position as a reference position.
Remote command:
[:SOURce<hw>]:VOR[:BANGle]:DIRection on page 575
VOR Configuration and Settings