List and Sweep Mode
R&S
®
SMA100B
180User Manual 1178.3834.02 ─ 05
The R&S SMA100B supplies the signal at the V/GHz X-Axis connector.
"0,25 V/GHz" /
"0,5 V/GHz" /
"1 V/GHz"
Supplies the voltage proportional to the set frequency, derived from
the selected setting.
"X-Axis"
Supplies a voltage range from 0 V to 10 V proportional to the fre-
quency sweep range, set with Start Frequency/Stop Frequency .
Remote command:
:OUTPut:FPRoportional:SCALe on page 446
Marker / User
Option: R&S SMAB-B28
Selects the signal to be supplied at the Marker User1 connector.
"Marker"
Assigns a marker signal to the output.
To configure and assign the marker signals, see Chapter 6.5.5, "Edit
Marker Settings", on page 180.
"User"
Intended for future use.
Remote command:
:OUTPut:USER:MARKer on page 447
6.5.5 Edit Marker Settings
Option: R&S SMAB-B28
Access:
1. Select "Sweep" > "RF Frequency Sweep"
2. Select "Marker".
Sweep Mode Settings
To Next Page
Loading...
