Remote Control Commands
R&S
®
SMA100B
447User Manual 1178.3834.02 ─ 05
Options: R&S SMAB-B28
Manual operation: See " V/GHz / X-Axis " on page 179
:OUTPut:USER:MARKer <SelUserMarker>
Selects the signal for output at the Marker User1 connector.
Parameters:
<SelUserMarker> MARK | USER
MARK
Assigns a marker signal to the output.
USER
Intended for future use.
*RST: MARK
Options: R&S SMAB-B28
Manual operation: See " Marker / User " on page 180
:OUTPut<hw>:AFIXed:RANGe:LOWer?
:OUTPut<hw>:AFIXed:RANGe:UPPer?
Queries the settable minimum/maximum value in mode :OUTPut:AMODe FIXed, i.e.
when the attenuator is not being adjusted.
See :OUTPut<hw>:AMODe on page 445
Return values:
<Upper> float
Increment: 0.01
Default unit: dBm
Example:
OUTPut1:AMODe FIXed
OUTPut1:AFIXed:RANGe:UPPer?
// -27
OUTPut1:AFIXed:RANGe:LOW?
// -50
Usage: Query only
Manual operation: See " Level Range " on page 196
:OUTPut<hw>:PROTection:CLEar
Resets the protective circuit after it has been tripped.
To define the output state, use the command :OUTPut<hw>[:STATe].
Example:
OUTP:PROT:CLE
Resets the protective circuit of the RF output.
Usage: Event
OUTPut Subsystem
To Next Page
Loading...
