Remote Control Commands
R&S
®
SMA100B
677User Manual 1178.3834.02 ─ 05
:SYSTem:RESTart
Restarts the instrument without restarting the operating system.
Usage: Event
:SYSTem:SHUTdown
Shuts down the instrument.
Usage: Event
Manual operation: See "Shut down" on page 697
:SYSTem:WAIT
<TimeMs>
Delays the execution of the subsequent remote command by the specified time.
This function is useful, for example to execute an SCPI sequence automatically but
with a defined time delay between some commands.
See Chapter 11.2.3, "Assigning Actions to the [★ (User)] Key", on page 326.
Setting parameters:
<TimeMs> integer
Wait time in ms
Range: 0 to 10000
*RST: 0
Example:
:SYSTem:WAIT 10000
// waits 10s before resetting the instrument
*RST
Usage: Setting only
:SYSTem:FILes:TEMPorary:DELete
Deletes the temporary files from the internal memory or, if installed, from the SD card
slot.
Example:
:SYSTem:FILes:TEMPorary:DELete
// temporary files are removed
Usage: Event
13.18 STATus Subsystem
This system contains the commands for the status reporting system. See also Chap-
ter A.1.5, "Status Reporting System", on page 722 for detailed information.
*RST on page 409 has no effect on the status registers.
STATus Subsystem
To Next Page
Loading...
