Rohde & Schwarz SMAB-B92 - Display and Keyboard Settings

General Instrument Functions
R&S
®
SMA100B
318User Manual 1178.3834.02 ─ 05
●
Set date and time for the system clock, see Chapter 14.3.1, "Date and Time Set-
tings", on page 689
●
Configure and activate a Screen Saver
●
Deactivate display update to improve performance, see Chapter 11.1.2, "Display
Update Settings", on page 319
●
Determine the state of the RF signal, and the level display in the status bar when
you turn on the R&S SMA100B, see Chapter 11.1.3, "Defining the RF Signal State
On Power On ", on page 320.
11.1.1 Display and Keyboard Settings
Access:
1. Select "System Config > Setup > User Interface > Display/Keyboard > Display".
2. Select "Display/Keyboard > USB Keyboard".
In the "Display/Keyboard" dialog, you can change regional and language options
for the GUI and an external keyboard, and define the screen saver settings.
The remote commands required to configure the display and keyboard are described in
Chapter 13.9, "DISPlay Subsystem", on page 432 and Chapter 13.12, "KBOard Sub-
system", on page 443.
Screen Saver.............................................................................................................. 319
Wait Time.................................................................................................................... 319
Display........................................................................................................................ 319
RF Hardkey.................................................................................................................319
USB Keyboard > Layout..............................................................................................319
Customizing the User Interface