Rohde & Schwarz SMAB-B92 - Check Front Panel Settings

Maintenance
R&S
®
SMA100B
692User Manual 1178.3834.02 ─ 05
14.3.2.1 Check Front Panel Settings
Access:
► Select "System Config > Setup > Maintenance > Check Front Panel".
Reflecting the front panel, the "Check Front Panel" dialog contains all functions to
test the operating elements of the instrument.
14.3.2.2 How to Test the Front Panel
How to perform the key panel test
To perform the key panel test, you operate the keys at the front panel, and check the
response of the instrument in the "Check Front Panel" dialog. To perform this test prop-
erly, check each key of the front panel. The test is only completed, when you have veri-
fied all keys.
During the test, the actual functions of the keys are disabled.
1. Press the [Setup] key.
2. Select "Maintenance > Check Front Panel"
The "Check Front Panel" dialog opens.
3. Press a key on the front panel.
Check if the corresponding key in the "Check Front Panel" dialog turns green.
4. Press the same key a second time.
Check that the key in the dialog turns red.
Performing Maintenance Tasks