Rohde & Schwarz SMAB-B92 - General Sweep Settings

List and Sweep Mode
R&S
®
SMA100B
170User Manual 1178.3834.02 ─ 05
Access:
1. Select "Sweep" > "RF Frequency Sweep"
2. Select "Sweep" > "RF Level Sweep"
3. Select "Sweep" > "LF Frequency Sweep"
The remote commands required to define these settings are described in:
●
Chapter 13.16.4, "SOURce:FREQuency Subsystem", on page 590
●
Chapter 13.16.13, "SOURce:SWEep Subsystem", on page 643
●
Chapter 13.16.6, "SOURce:LFOutput Subsystem", on page 599
Settings
● General Sweep Settings....................................................................................... 170
● Frequency Range Settings....................................................................................175
● Level Range Settings............................................................................................177
● Output Settings..................................................................................................... 179
● Edit Marker Settings..............................................................................................180
6.5.1 General Sweep Settings
Access:
► Select for example "Sweep" > "RF Frequency Sweep".
Sweep Mode Settings