Rohde & Schwarz SMAB-B92 - Pulse Modulation

Analog Modulations
R&S
®
SMA100B
76User Manual 1178.3834.02 ─ 05
The remote commands required to define these settings are described in:
● Chapter 13.16.1.2, "SOURce:AM Subsystem", on page 513
● Chapter 13.16.1.3, "SOURce:FM Subsystem", on page 519
● Chapter 13.16.1.4, "SOURce:PM Subsystem", on page 524
● Chapter 13.16.1.5, "SOURce:PULM Subsystem", on page 528
● Chapter 13.16.6, "SOURce:LFOutput Subsystem", on page 599
4.4.1 Pulse Modulation
Option: see Chapter 4.1, "Required Options", on page 73.
Access:
► Select "Modulation" > "Pulse Modulation".
The "Pulse Modulation" dialog contains all parameters required to configure the
pulse modulator and the pulse generator.
It also displays the pulse signal graphically.
For an overview of the supported signals sources and related connectors, see Chap-
ter 4.2, "Modulation Types and Signal Sources", on page 73.
The remote commands required to define these settings are described in Chap-
ter 13.16.1.5, "SOURce:PULM Subsystem", on page 528.
Settings:
State..............................................................................................................................76
Source...........................................................................................................................77
Transition Type..............................................................................................................77
Video Polarity................................................................................................................77
State
Activates pulse modulation and triggers the following automatic settings:
●
Pulse generator is activated.
Modulation Settings