Rohde & Schwarz SMAB-B92 - Page 183

List and Sweep Mode
R&S
®
SMA100B
181User Manual 1178.3834.02 ─ 05
You can define up to 10 markers, and assign one of them to the output at a time.
When the sweep run has reached the marker frequency, the R&S SMA100B acti-
vates the marker signal and supplis it at the Marker User1 connector. The duration
of the active signal corresponds to the dwell time of a step.
Settings
Frequency x ............................................................................................................... 181
State ...........................................................................................................................181
Marker Polarity............................................................................................................182
Active Marker ............................................................................................................. 182
Frequency x
Sets the frequency that the selected marker indicates.
When the specified value is used, the polarity of the marker signal changes, as
selected with the parameter .
Remote command:
[:SOURce<hw>]:SWEep[:FREQuency]:MARKer<ch>:FREQuency on page 652
State
Enables the selected marker.
A marker signal at the output connector marks the moment the specified frequency val-
ues is used.
Remote command:
[:SOURce<hw>]:SWEep[:FREQuency]:MARKer<ch>:FSTate on page 653
Sweep Mode Settings