Rohde & Schwarz SMAB-B92 - Page 178

List and Sweep Mode
R&S
®
SMA100B
176User Manual 1178.3834.02 ─ 05
Settings
Start Frequency/Stop Frequency ............................................................................... 176
Center Frequency ...................................................................................................... 176
Span............................................................................................................................176
Spacing....................................................................................................................... 176
Step Linear/Step Logarithmic .....................................................................................177
Start Frequency/Stop Frequency
Defines the frequency sweep range by setting the start and end values.
See Chapter 6.2.1, "Correlating Parameters in Sweep Mode", on page 164.
Remote command:
[:SOURce<hw>]:FREQuency:STARt on page 595
[:SOURce<hw>]:FREQuency:STOP on page 595
[:SOURce<hw>]:LFOutput:FREQuency:STARt on page 604
[:SOURce<hw>]:LFOutput:FREQuency:STOP on page 604
Center Frequency
In "RF Frequency Sweep" mode, sets the RF center frequency.
See Chapter 6.2.1, "Correlating Parameters in Sweep Mode", on page 164.
Remote command:
[:SOURce<hw>]:FREQuency:CENTer on page 594
Span
In "RF Frequency Sweep" mode, sets the span of the frequency sweep range.
See Chapter 6.2.1, "Correlating Parameters in Sweep Mode", on page 164.
Remote command:
[:SOURce<hw>]:FREQuency:SPAN on page 595
Spacing
In "RF and LF Frequency Sweep" modes, selects the mode for the calculation of the
frequency intervals, with which the current frequency at each step is increased or
decreased.
Enter the step size with the parameter Step Linear/Step Logarithmic .
This parameter is only available for Sweep Type > Step.
Sweep Mode Settings