Rohde & Schwarz SMAB-B92 - Page 574

Remote Control Commands
R&S
®
SMA100B
572User Manual 1178.3834.02 ─ 05
[:SOURce<hw>][:ILS]:MBEacon:COMid:TSCHema <Tschema>
Sets the time schema of the Morse code for the COM/ID signal.
Parameters:
<Tschema> STD | USER
STD
Activates the standard time schema of the Morse code.
The set dot length determines the dash length, which is 3
times the dot length.
USER
Activates the user-defined time schema of the Morse code.
Dot and dash length, as well as symbol and letter space
can be set separately.
*RST: STD
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 544.
Manual operation: See "Time Schema" on page 147
[:SOURce<hw>][:ILS]:MBEacon:COMid[:STATe] <State>
Enables/disables the COM/ID signal.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 544.
Manual operation: See "COM/ID State" on page 147
[:SOURce<hw>][:ILS]:MBEacon:FREQuency <CarrierFreq>
Sets the carrier frequency for the ILS marker beacon signal.
Parameters:
<CarrierFreq> float
Range: 100E3 to 6E9
Increment: 0.01
*RST: 75E6
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 544.
Manual operation: See "Carrier Frequency" on page 144
[:SOURce<hw>][:ILS]:MBEacon:FREQuency:MODE <Mode>
Sets the carrier frequency mode of the ILS marker beacon signal.
SOURce Subsystem