Rohde & Schwarz SMAB-B92 - Page 571

Remote Control Commands
R&S
®
SMA100B
569User Manual 1178.3834.02 ─ 05
Parameters:
<Sdm> float
Range: 0 to 100
Increment: 0.1
*RST: 40
Example: See Example "Configure and generate an ILS localizer signal"
on page 543.
Manual operation: See "Sum of Depth" on page 139
[:SOURce<hw>]:ILS:LOCalizer:SOURce
<IlsLocSource>
Sets the modulation source for the avionic standard modulation.
If external modulation source is set, the external signal is added to the internal signal.
Switching off the internal modulation source is not possible.
Parameters:
<IlsLocSource> INT | INT,EXT | EXT
INT
Internal modulation source is used.
EXT|INT,EXT
An external modulation source is used, additional to the internal
modulation source.
The external signal is input at the Ext connector.
Example: See Example "Configure and generate an ILS localizer signal"
on page 543.
Manual operation: See "EXT AM" on page 127
[:SOURce<hw>][:ILS]:MBEacon:COMid:CODE <Code>
Sets the coding of the COM/ID signal by the international short name of the airport
(e.g. MUC for the Munich airport).
The COM/ID tone is sent according to the selected code, see Chapter D, "Morse Code
Settings", on page 740.
If no coding is set, the COM/ID tone is sent uncoded (key down).
Parameters:
<Code> string
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 544.
Manual operation: See "Code" on page 147
[:SOURce<hw>][:ILS]:MBEacon:COMid:DASH <Dash>
Sets the length of a Morse code dash.
SOURce Subsystem