Rohde & Schwarz SMAB-B92 - Page 149

Avionic Standards
R&S
®
SMA100B
147User Manual 1178.3834.02 ─ 05
Settings
COM/ID State..............................................................................................................147
Code............................................................................................................................147
Period..........................................................................................................................147
Frequency................................................................................................................... 147
Depth...........................................................................................................................147
Time Schema.............................................................................................................. 147
Dot Length...................................................................................................................148
Dash Length................................................................................................................148
Symbol Space ............................................................................................................148
Letter Space ...............................................................................................................148
COM/ID State
Enables/disables the COM/ID signal.
See also Chapter D, "Morse Code Settings", on page 740.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid[:STATe] on page 572
Code
Sets the coding of the COM/ID signal by the international short name of the airport
(e.g. MUC for the Munich airport).
The COM/ID tone is sent according to the selected code, see Chapter D, "Morse Code
Settings", on page 740.
If no coding is set, the COM/ID tone is sent uncoded (key down).
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid:CODE on page 569
Period
Sets the period of the COM/ID signal.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid:PERiod on page 571
Frequency
Sets the frequency of the COM/ID signal.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid:FREQuency on page 570
Depth
Sets the AM modulation depth of the COM/ID signal.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid:DEPTh on page 570
Time Schema
Sets the time schema of the Morse code for the COM/ID signal.
●
"Standard"
ILS Configuration and Settings