Rohde & Schwarz SMAB-B92 - Page 74

RF Signal Configuration
R&S
®
SMA100B
72User Manual 1178.3834.02 ─ 05
2. Observe the information on the home screen, "Frequency" tile.
The "Frequency" tile indicates used reference frequency, current frequency offset
and multiplier values, and the delta phase value.
The remote commands required to define the settings are described in Chap-
ter 13.16.10, "SOURce:PHASe Subsystem", on page 628.
Settings
Delta Phase...................................................................................................................72
Reset Delta Phase Display........................................................................................... 72
Delta Phase
Sets the phase of the RF signal.
The current phase of the signal is used as the reference.
Remote command:
[:SOURce<hw>]:PHASe on page 628
Reset Delta Phase Display
Adopts the selected "Delta Phase" value as the current value, and resets delta phase
to 0 degrees.
Remote command:
[:SOURce<hw>]:PHASe:REFerence on page 628
RF Phase Settings