Rohde & Schwarz SMAB-B92 - Page 643

Remote Control Commands
R&S
®
SMA100B
641User Manual 1178.3834.02 ─ 05
NARRow
The synchronization bandwidth is a few Hz.
Suitable for external reference sources with phase noise worse
than the R&S SMA100B.
WIDE
Uses the widest possible synchronization bandwidth.
For more information, see data sheet.
*RST: n.a. (factory preset)
Example: See Example "Configuring the reference oscillator" on page 638.
Manual operation: See "Synchronization Bandwidth" on page 274
[:SOURce]:ROSCillator:EXTernal:MLRange?
Queries the minimum locking range for the selected external reference frequency.
Return values:
<MinLockRange> string
Example:
SOUR:ROSC:EXT:MLR?
Usage: Query only
Manual operation: See "Minimum Locking Range" on page 274
[:SOURce]:ROSCillator:EXTernal:NSBandwidth?
Queries the nominal synchronization bandwidth for the selected external reference fre-
quency and synchronization bandwidth.
Return values:
<NomBandwidth> string
Example:
SOUR:ROSC:EXT:NSB?
Usage: Query only
Manual operation: See "Nominal Synchronization Bandwidth" on page 274
[:SOURce]:ROSCillator:OUTPut:FREQuency:MODE <OutpFreqMode>
Sets the output reference frequency.
Parameters:
<OutpFreqMode> DER10M | DER100M | OFF | LOOPthrough
OFF
Disables the output.
DER10M|DER100M
Sets the output reference frequency to 10 MHz or 100 MHz.
The reference frequency is derived from the internal reference
frequency.
SOURce Subsystem