Rohde & Schwarz SMAB-B92 - Page 159

List and Sweep Mode
R&S
®
SMA100B
157User Manual 1178.3834.02 ─ 05
Auto mode (Sweep/List)
Figure 6-3: Auto mode (Sweep/List)
●
The instrument generates the signal continuously.
●
Trigger mode "Auto" is prerequisite (default). It causes the continuous generation
of the sweep signal.
●
Starts signal generation immediately with "State = On".
●
Switches automatically to the next step when the Dwell time has elapsed.
●
Stops signal generation with "State = Off".
Table 6-1: Cross-reference between manual and remote control in Auto mode (Sweep/List)
Manual control mode:
"Auto"
Remote commands
Rohde & Schwarz proprietary and [SCPI conform] value name
RF frequency sweep
:TRIGger<hw>:FSWeep:SOURce AUTO [IMMediate]
:SOURce<hw>:SWEep:FREQuency:MODE AUTO
RF level sweep
:TRIGger<hw>:PSWeep:SOURce AUTO [IMMediate]
:SOURce<hw>:SWEep:POWer:MODE AUTO
LF frequency sweep
:TRIGger<hw>:LFFSweep:SOURce AUTO [IMMediate]
:SOURce<hw>:LFOutput<ch>:SWEep:FREQuency:MODE AUTO
List
:SOURce<hw>:LIST:MODE AUTO
:SOURce<hw>:LIST:TRIGger:SOURce AUTO
Signal Generation and Triggering in the Sweep and List Modes