Improving Level Performance
R&S
®
SMA100B
235User Manual 1178.3834.02 ─ 05
The "Configure Diagram" covers the parameters for scaling the y-axis and the appear-
ance of the diagram.
Min - Max Level - Power Analysis
Selects the minimum and maximum value of the y-axis.
Remote command:
:SENSe[:POWer]:SWEep:FREQuency:YSCale:MAXimum on page 469
:SENSe[:POWer]:SWEep:FREQuency:YSCale:MINimum on page 469
:SENSe[:POWer]:SWEep:POWer:YSCale:MAXimum on page 482
:SENSe[:POWer]:SWEep:POWer:YSCale:MINimum on page 482
:SENSe[:POWer]:SWEep:TIME:YSCale:MAXimum on page 487
:SENSe[:POWer]:SWEep:TIME:YSCale:MINimum on page 487
Auto Scale - Power Analysis
Activates autoscaling of the y-axis of the diagram. The "Auto Scale" function adjusts
the scale divisions so that the entire trace fits into the diagram area.
"Off"
Auto scale is deactivated. Switching from activated to deactivated,
the scaling is maintained.
"Expand Only (Course/Fine)"
Auto scale is activated. Automatically selects the appropriate scaling
of the y-axis so that the trace is always visible. The range is expan-
ded when a value is out of the right or the left end-of-scale value. The
step width is 5 dB for selection "Exp. (Coarse)" and variable in the
range of 0.2 db to 5 dB for selection "Exp. (Fine)".
Using Power Sensors
To Next Page
Loading...
