Rohde & Schwarz SMAB-B92 - Page 308

File and Data Management
R&S
®
SMA100B
306User Manual 1178.3834.02 ─ 05
●
Enable the corresponding service or interface
To enable write permission on the file system
1. Select "System Config > Setup > Security > Security > General"
2. Enable "Volatile Mode"
3. Enter the "Security Password".
The default password is 123456. For more information, see Chapter 11.4, "Using
the Security Settings", on page 332.
4. Select "System Config > Setup > Maintenance > Shut Down"
5. Select "Reboot".
The system reboots. The enabled settings are active.
To enable file transfer via ftp
1. Select "System Config > Setup > Security > Security > LAN Services".
2. Enable "LAN Interface"
3. Enable "FTP"
4. Enter the "Security Password".
The default password is 123456. For more information, refer to Chapter 11.4,
"Using the Security Settings", on page 332.
5. Select "Accept".
To enable file transfer via SMB (samba)
1. Select "System Config > Setup > Security > Security > LAN Services"
2. Enable "LAN Interface"
3. Enable "SMB (Samba)"
4. Enter the "Security Password".
The default password is 123456. For more information, refer to Chapter 11.4,
"Using the Security Settings", on page 332.
5. Select "Accept".
To enable file transfer via USB
1. Select "System Config > Setup > Security > Security > General"
2. Enable "USB Storage"
3. Enter the "Security Password".
The default password is 123456. For more information, refer to Chapter 11.4,
"Using the Security Settings", on page 332.
4. Select "Accept".
How to Transfer Files from and to the Instrument