Remote Control Commands
R&S
®
SMA100B
450User Manual 1178.3834.02 ─ 05
:CALCulate[:POWer]:SWEep:FREQuency:MATH<ch>:SUBTract <Subtract>
Subtracts the operands 1 and 2 and assigns the result to the selected trace in "Fre-
quency" measurement mode.
Parameters:
<Subtract> T1T1 | T1T2 | T1T3 | T1T4 | T1REf | T2T1 | T2T2 | T2T3 | T2T4 |
T2REf | T3T1 | T3T2 | T3T3 | T3T4 | T3REf | T4T1 | T4T2 |
T4T3 | T4T4 | T4REf
Example:
CALC:POW:SWE:FREQ:MATH4:SUBT T2REF
Subtracts the Reference and Trace 2, and assigns the result to
Trace 4. The resulting curve is shown in the diagram.
Options: R&S SMAB-K28
Manual operation: See " Mathematics - Trace Power Analysis " on page 228
:CALCulate[:POWer]:SWEep:POWer:MATH<ch>:STATe <State>
Activates the trace mathematics mode for "Power" measurement. This feature enables
you to calculate the difference between the measurement values of two traces. For fur-
ther calculation, a math result can also be assigned to a trace.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
CALC:POW:SWE:POW:MATH2:STATe
Switches on math mode in trace 2.
Options: R&S SMAB-K28
Manual operation: See " Mathematics - Trace Power Analysis " on page 228
:CALCulate[:POWer]:SWEep:POWer:MATH<ch>:SUBTract <Subtract>
Subtracts the operands 1 and 2 and assigns the result to the selected trace in "Power"
measurement mode.
Parameters:
<Subtract> T1T1 | T1T2 | T1T3 | T1T4 | T1REf | T2T1 | T2T2 | T2T3 | T2T4 |
T2REf | T3T1 | T3T2 | T3T3 | T3T4 | T3REf | T4T1 | T4T2 |
T4T3 | T4T4 | T4REf
Example:
CALC:POW:SWE:POW:MATH4:SUBT T2REF
Subtracts the Reference and Trace 2, and assigns the result to
Trace 4. The resulting curve is shown in the diagram.
Options: R&S SMAB-K28
Manual operation: See " Mathematics - Trace Power Analysis " on page 228
Power Sensor Measurement Subsystems
To Next Page
Loading...
